Video and access control software
for installers.
Connect, configure and fix your customers' cameras, access control and door stations, every brand.
Every camera checked
when it is connected.
A clock that is off, a closed port, a password refused: you know straight away, and what to do about it. A badly set stream is fixed at once.
Cameras, controllers and door stations
connected the same way.
You enter the device's address: the controller's doors and the door station's intercom are picked up in one go.
Settings checked
on the camera.
Image, recording, time, detection: set from the office. Each setting is read back from the camera: you know whether it was kept, without going back on site.
Detection
Recording
Time
Image
The device did not take the whole setting: here is what it kept.
Not kept by the camera: Sensitivity.
Kept: Before a detection: 5 s → 10 s · NTP sync: no → yes · Brightness: 50 → 62
GateRead back from the camera
A site handed over
to the customer in one click.
You prepare the site, then mark it as done; your customer puts it into service. You keep maintenance access, without seeing their recordings.
Faults on your sites,
fixed remotely.
An unreachable camera, a full or faulty disk: you see it for each of your sites. You can restart a camera or format its card without going on site.
Needs a site visit
Sees everything. Stays with you.
Book a demo










